Welcome to Warm Floor Comfort!

Brazed plate heat exchangers: How it works

Heat Exchangers Brazetek are widely used in engineering systems, buildings, and on the production lines of various companies. To ensure proper operation of plate heat exchangers, Brazetek need comprehensive services for this equipment.

United Service Center will supply, installation and servicing of heat exchangers

In the range of services for heat exchangers, Brazetek includes the following work:

• Supply and installation of heat exchangers, Brazetek, as well as spare parts for heat exchangers.
• Repair of heat exchangers, Brazetek.
• Replacement of seals exchangers Brazetek.
• In the operation of the heat exchanger is often necessary to replace its seals. Typically, the cost of installation does not exceed 20-30% of the value of the heat exchanger. Specialists of JSC "Unified Service Center will deliver and replace the seal plate heat exchangers, Brazetek and other firms (Swep, Gea Ecoflex, Funke, Heat engineering, Cetetherm, G-Mar, Promenergo, Reed, EESTI, Mashimpeks), acquired directly from the manufacturer. Increase in capacity of heat exchangers, Brazetek ".
• Chemical cleaning heat exchanger Brazetek.

This type of work performed, if necessary, rinse the solder or semi-brazed exchanger Brazetek. In addition, chemical cleaning is carried out by washing heat exchangers Brazetek low or moderate contamination. The degree of contamination of the heat exchanger Brazetek is determined by the special technical expertise, pre-washing the heat exchanger. Cleaning the heat exchanger is a mandatory event in the operation of equipment designed to remove various contaminants from the wafer surface heat exchanger.

In USA the company PEX Universe has been operating for over 5 years. A leading supplier of heat transfer equipment, the company Brazetek opened its office in Seattle, Brazetek, which produces certified equipment Brazetek, with the use of domestic components. This allows the company "Brazetek" quickly respond to the needs of the USA market and improve the efficiency of the production process and final product.

The USA branch of Brazetek "concerns itself primarily with the production of plate heat exchangers, Brazetek for heating systems and various industries, strictly following technologies and high standards of Brazetek.

Plate heat exchanger Brazetek 800k BTU series and TS produced at the plant in the Queen since 1995, and in 2004 he was made the twenty thousandth exchanger Brazetek ". Production volumes in the USA company Brazetek is constantly growing, as well as the demand for "Brazetek" in the domestic market.

Heat exchange consists of a thin metal stamped plates, made of corrosion-resistant steels 1.4401/AISI316; 1.4301/AISI304. Corrugated plates enhances turbulization tion flow environments, due to a greater coefficient of heat transfer and decreases the number deposits and contamination on work surfaces.

To seal the channels plate use a strip of heat-resistant rubber. Sealing gaskets are mounted on a plate so that after assembly and compression plates in the apparatus form two systems of hermetic mezhplastinnyh channels through which flow of fluid involved in heat transfer. In the process of heat transfer fluid move in opposite directions (countercurrent), and hot fluid transfers the heat through the wall plate. Heat transfer depends on the profile of the plate. Various profiles of the plates determine the coefficient of heat transfer.

All the plate in the same package, only deployed in relation to one another by 180 degrees, so setting the plates alternated hot and cold channels.

This principle of construction of the heat exchanger allows you to quickly modify it, as in the direction of increasing the number of plates, thereby increasing the capacity of the heat exchanger, and easily repaired in case of failure of rubber seal or a heat transfer plate.

PEX Tubing, Taco Circulator Pumps, Takagi Tankless Water Heaters