Welcome to Warm Floor Comfort!

Installation Scheme - The Right PEX Plumbing Manifold

PEX manifold used in PEX plumbing is made of cross linked polyethylene that makes it stronger and more long lasting. As a result, they can resist extreme temperature without being damaged. As you draft your PEX plumbing project, it is good to understand the scheme that one has so as to guide them in choosing the right PEX manifolds.

In this scheme, one does not need coupling fitting. It makes use of trunk lines that in turn provide branch lines which run through, to the fixtures. The PEX pipes reduce chances of leakages and due to the flexibility of the PEX pipes they allow sweeping turns.

Hot and cold water copper manifolds deliver water in the house. For the PEX plumbing system, the heater and the main water lines are connect and fed to the manifold. Smaller lines then move from the manifold to the various fixtures. In your PEX plumbing system, the plumbing manifold needs to be installed in a central area of the house. Cold water manifold is installed next to the heater manifold that in turn installed about 18" from the heater.

The remote manifold scheme combines both the home run and trunk and branch schemes. The Manifolds are installed close to multiple fittings in locations that can be easily accessed. This plumbing scheme requires more fittings than the home run but it uses less PEX pipes.

It redistributes water that has been heated, and the manifolds are set in group fixtures. For the return line to create an extension to heated water supply, open ended manifolds are required. This is a cost effective and energy saving scheme due to the redistribution of heated water.

It uses several flow - through manifolds instead of central manifolds. Less PEX pipes are used in this scheme. The system delivers heated water faster than any other.

Installation of the PEX plumbing manifold for the project can be simplified when the right procedure is followed. The tubes are measured to meet the requirements of the point of installation. As one begins the installation of the project components, add an additional ½" for the space of the gauge. With measurements done you can cut the PEX pipes and install the gauges and also the PEX plumbing manifolds that one has chosen in relation to the scheme.

PEX Tubing, Taco Circulator Pumps, Takagi Tankless Water Heaters